ZyXEL Prestige 202H Plus ISDN Router 91-003-154001B 用户手册

P-202H Plus v2 User’s Guide

Chapter 29 Firmware and Configuration File Maintenance

272

Figure 169   Telnet in Menu 24.5

1 Launch the FTP client on your computer.

2 Enter “open”, followed by a space and the IP address of your ZyXEL Device.  

3 Press [ENTER] when prompted for a username.

4 Enter your password as requested (the default is “1234”).

5 Enter “bin” to set transfer mode to binary.

6 Use “get” to transfer files from the ZyXEL Device to the computer, for example, “get 

rom-0 config.rom” transfers the configuration file on the ZyXEL Device to your 
computer and renames it “config.rom”. See earlier in this chapter for more information on 
filename conventions.

7 Enter “quit” to exit the ftp prompt. 

Figure 170   FTP Session Example

                     Menu 24.5 - Backup Configuration

To transfer the configuration file to your workstation, follow the procedure
below:

  1. Launch the FTP client on your workstation.
  2. Type "open" and the IP address of your router. Then type "root" and
     SMT password as requested.
  3. Locate the 'rom-0' file.
  4. Type 'get rom-0' to back up the current router configuration to
     your workstation.

For details on FTP commands, please consult the documentation of your FTP
client program.  For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your router manual.

Press ENTER to Exit:

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit