Kingston Technology KHX18C10T3K2/16X KHX18C10T3K216X 产品宣传页

Kingston's KHX18C10T3K2/16X is a kit of two 1G x 64-bit

(8GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 2Rx8

memory modules, based on sixteen 512M x 8-bit DDR3 FBGA

components per module. Each module kit supports Intel

(Extreme Memory Profiles). Total kit capacity is 16GB. Each

module kit has been tested to run at DDR3-1866 at a low

latency timing of 10-10-10 at 1.5V. The SPDs are programmed

to JEDEC standard latency DDR3-1600 timing of 11-11-11 at

1.5V. Each 240-pin DIMM uses gold contact fingers and

requires +1.5V. The JEDEC standard electrical and mechanical

specifications are as follows:

CL(IDD)

11 cycles

Row Cycle Time (tRCmin)

48.125ns (min.)

Refresh to Active/Refresh

260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin)

35ns (min.)

Maximum Operating Power

2.580 W* (per module)

UL Rating

94 V - 0

Operating Temperature

0

o

 C to 85

o

 C

Storage Temperature

-55

o

 C to +100

o

 C

*Power will vary depending on the SDRAM used.

•

JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

•

VDDQ = 1.5V (1.425V ~ 1.575V)

•

800MHz fCK for 1600Mb/sec/pin

•

8 independent internal bank

•

Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•

8-bit pre-fetch

•

Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

•

Bi-directional Differential Data Strobe

•

Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•

On Die Termination using ODT pin

•

Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•

Asynchronous Reset

•

PCB : Height 1.827” (46.41mm) w/ heatsink, double  sided
component

Memory Module Specifi cations

16GB (8GB 1G x 64-Bit x 2 pcs.)
DDR3-1866 CL10 240-Pin DIMM Kit

Continued >>

•

JEDEC: DDR3-1600 CL11-11-11 @1.5V

•

XMP Profile #1: D3-1866 CL10-10-10 @1.5V

•

XMP Profile #2: D3-1600 CL9-9-9 @1.5V