Intermec 073298-001 用户手册

Replace the mini PCI shield assembly by threading the Ethernet cable 
through the opening in the shield and replacing the four Phillips screws. 

Connect the Ethernet cable to J12 on the main PCB. 

Close the CK30. For help, see “Closing the CK30” on page 27. 

To replace the Bluetooth radio, you need the following tools and parts: 

•  T10 Torx screwdriver 

•  Small Phillips screwdriver 

•  Bluetooth radio (P/N 855-050-001) 

•  Phillips 4-40 x .875 screw (P/N 590939-001) 

•  Elco screw (591825-001) 

 

Open the CK30. For help, see “Opening the CK30” on page 9. 

Disconnect the power/good read indicator light pipe assembly cable 
and the speaker PCB assembly cable from the main PCB. 

 

 

Power/good
read indicator
light pipe  
assembly
cable

Speaker
PCB assembly
cable

 

Remove the two Phillips screws with captive washers from the top of the 
main PCB and gently separate the main PCB from the top cover as 
shown in the next illustration. 

Detach the display flex cable and the keypad flex cable from the main 
PCB. 

From the backside of the main PCB, remove the Phillips screw that 
attaches the Bluetooth radio retaining clip and pull it away from the 
main PCB.