Intermec 073292-001 用户手册
Chapter 1 — Troubleshooting
Troubleshooting the CK30 (continued)
Problem
Solution
Nothing is displayed on the
screen.
screen.
Try these possible solutions in order:
•
The contrast may be set too light or too dark. Press
B and then E repeatedly until you reach the desired
contrast level.
B and then E repeatedly until you reach the desired
contrast level.
•
If you have a CK30 with a color screen, make sure the
backlight is on by pressing E.
backlight is on by pressing E.
•
The display flex cable may be disconnected. Make
sure the display flex cable is connected to the display
assembly and the main PCB.
sure the display flex cable is connected to the display
assembly and the main PCB.
•
The display assembly may be damaged. For help, see
the “Replacing the Display Assembly” procedure on
page 18.
the “Replacing the Display Assembly” procedure on
page 18.
•
The main PCB assembly display interface may have
failed. For help, see the “Replacing the Main PCB”
procedure on page 15.
failed. For help, see the “Replacing the Main PCB”
procedure on page 15.
Backlight does not work.
Try these possible solutions in order:
•
Make sure you have a charged battery installed
correctly. For help, see “Charging and Installing the
Battery” in the CK30 Handheld Computer User’s
Manual.
correctly. For help, see “Charging and Installing the
Battery” in the CK30 Handheld Computer User’s
Manual.
•
The display assembly may be damaged. For help, see
the “Replacing the Display Assembly” procedure on
page 18.
the “Replacing the Display Assembly” procedure on
page 18.
•
The backlight key on the keypad assembly may not be
working properly. For help, see the “Replacing the
Keypad Assembly” procedure on page 20.
working properly. For help, see the “Replacing the
Keypad Assembly” procedure on page 20.
•
The backlight driver on the main PCB assembly may
have failed. For help, see the “Replacing the Main
PCB” procedure on page 15.
have failed. For help, see the “Replacing the Main
PCB” procedure on page 15.
Scanner does not emit a
beam, or scanner emits a
beam but does not scan the
bar code.
beam, or scanner emits a
beam but does not scan the
bar code.
Try these possible solutions in order:
•
Make sure the scanner window is clean. If the scanner
window is badly scratched, replace the scanner
window.
window is badly scratched, replace the scanner
window.
•
Make sure the keypad flex cable is connected properly.
•
Make sure the scan engine flex cable is connected
properly. If the scan engine flex cable is damaged,
replace it.
properly. If the scan engine flex cable is damaged,
replace it.
•
The scan engine may be damaged. For help, see one
of these procedures: “Replacing the SE1200 Scanner”
on page 21, “Replacing the EV10 Scanner” on page
23, or “Replacing the IT4000 Imager” on page 25.
of these procedures: “Replacing the SE1200 Scanner”
on page 21, “Replacing the EV10 Scanner” on page
23, or “Replacing the IT4000 Imager” on page 25.
CK30 Handheld Computer Service Manual
3