ZyXEL 202H 91-003-194001B 用户手册

P-202H Plus v2 User’s Guide

303

Chapter 33 VPN/IPSec Setup

Select Edit in the Select Command field, type the index number of a rule in the Select Rule 
field and press [ENTER] to edit the VPN using the menu shown next.

Note: You must also configure menu 27.1.1.1 or menu 27.1.1.2 to fully configure and 

use a VPN.

Figure 205   Menu 27.1.1 IPSec Setup

Select 

Command

Press [SPACE BAR] to choose from None, Edit or Delete and then press [ENTER]. 

You must select a rule in the next field when you choose the Edit or Delete  commands. 
Select None and then press [ENTER] to go to the “Press ENTER to Confirm…” prompt.
Use Edit to create or edit a rule. Use Delete to remove a rule. To edit or delete a rule, 

first make sure you are on the correct page. When a VPN rule is deleted, subsequent 

rules do not move up in the page list.

Select Rule

Type the VPN rule index number you wish to edit or delete and then press [ENTER].

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to 

save your configuration, or press [ESC] at any time to cancel.

Table 100   Menu 27.1 IPSec Summary

                        Menu 27.1.1 - IPSec Setup

Index #= 1        Name= Taiwan
Active= No        Keep Alive= No
Local ID type= IP         Content=
My IP Addr= 0.0.0.0
Peer ID type= E-MAIL      Content=
Secure Gateway Addr= 193.81.13.2
Protocol= 0
Local:  Addr Type= RANGE
    IP Addr Start= 192.168.1.35     End/Subnet Mask= 192.168.1.38
       Port Start= 0                End= N/A
Remote: Addr Type= RANGE
    IP Addr Start= 172.16.2.40      End/Subnet Mask= 172.16.2.46
       Port Start= 0                End= N/A
Enable Replay Detection= No
Key Management= IKE
Edit Key Management Setup= No

               Press ENTER to Confirm or ESC to Cancel: