Cisco 1-port ISDN BRI S/T WAN Interface Card WIC-1B-S/T-V3 数据表
产品代码
WIC-1B-S/T-V3
© 2005 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 2 of 6
•
Physical space savings
The ability to add BRI connectivity via a WIC enables administrators to maximize valuable slot space while providing additional connectivity
options on the same module such as Fast Ethernet.
FLEXIBILITY AND INVESTMENT PROTECTION
The Cisco 1 port BRI-S/T WIC extends the Cisco commitment to providing customers with maximum flexibility and investment protection through
modular WICs that are supported on award-winning router platforms. When WAN bandwidth requirements or service provider pricing change, users
can easily change WAN services either by changing the software configuration or replacing the WIC. Because the same card can be used on Cisco
1600, 1700, 1800, 2600, 2800, 3700 or 3800 series router platforms, the number of stocking units can be reduced, and the WIC can be redeployed
from one platform to another.
ENHANCED RELIABILITY
An integrated solution has fewer components; hence, fewer points of failure (for example, one less power supply and fewer cables). This leads to
enhanced reliability.
CONSISTENCY WITH WIC-1B-S/T
The Cisco WIC-1B-S/T-V3 offers all of the features of the Cisco WIC-1B-S/T and can be smoothly deployed without requiring any additional
learning.
WIC-1B-S/T
WIC-1B-S/T-V3
One ISDN BRI port (S/T interface, requires external NT1)
One ISDN BRI port (S/T interface, requires external NT1)
RJ-45 connector
RJ-45 connector
Supported on Cisco 1600, 1700, 2600, 3600, and series
Supported on Cisco 1700, 1800, 2600, 2800, 3660, 3700 and 3800
series (see tables below)
Cannot be used with Cisco 1603 or 1604 base units
Cannot be used with Cisco 1603 or 1604 base units
Does not support hot swapping; however, no hardware damage will
occur if it is swapped while power is on
Does not support hot swapping; however, no hardware damage will
occur if it is swapped while power is on
Can go into slot W0 or W1 of the 1E2W, 2E2W, and 1E1R2W
network modules
Does not support the 1E2W, 2E2W, and 1E1R2W, NM-1FE2W, NM-
2FE2W network modules
Supported in NM-1FE1R2W, NM-1FE2W, NM-2FE2W, NM-
1FE2W-V2, NM-2FE-2W-V2, and NM-2W
Supported Onboard, NM-1FE2W-V2, NM-1FE1R2W, NM-2FE2W-
V2 and NM-2W
Note:
The Cisco IOS Software releases provided are typically the minimum version required to support the platform, module, or feature
in question. Use the Software Advisor to choose appropriate software for your network device: match software features to Cisco IOS and Cisco
Catalyst
Catalyst
®
Operating System (Catalyst OS) releases, compare Cisco IOS releases, or find out which software releases support your hardware. The
Software Advisor and other tools are available in TAC Tools for Access-Dial Technologies.