B-Tech BT26 BT26/S 产品宣传页

•  With many current amplifiers lacking a ‘Phono’ stage, this is

 the ideal accessory to connect a turntable to any amplifier
•  Suitable for use with turntables with magnetic cartridges
•  Also suitable for use with stereo and mono microphones
•  Designed to RIAA specifications with IC technology for

 low noise, high gain pre-amplification
•  CE certified
•  Power supply included
•  Available in Silver

© 2011 B-Tech International Limited, a division of Bennett Technologies Limited.  All rights reserved. The information in this specification sheet reflects the current technical specifications at the time of print.  We reserve the right to change the technical or physical specifications without prior notice.
The B-Tech name, the B-Tech logo and Better by Design are all registered trademarks of B-Tech International Ltd.  All other brands and products are trademarks of their respective owners. All B-Tech images and symbols are exclusive property of B-Tech International Ltd.  B-Tech accept no liability for loss or 
damage caused by improper installation or mounting on unstable structures. Any reproduction or retransmission or republication of any part of this specification sheet is strictly prohibited, unless prior written permission has been granted by B-Tech International Ltd.  E&OE. 

B-TECH AUDIO VIDEO MOUNTS

AND ACCESSORIES

SS-BT26-V1-060711   Page 1 of 1

audio video

Controls

audio video

Controls

40mm (1.6")

113mm (4.4")

70mm (2.7")

Load Impedance: >10K ohms

  Set slide switch to ‘Phono’ position. 

  Connect Phono output sockets

  to aux input of stereo amplifier.

  Connect turntable with magnetic    

  cartridge to Phono input sockets

  using screened Phono leads  

  (sold separately).

  Set slide switch to Mic position.

  Connect Phono output sockets

  to aux input of stereo amplifier

  using screened Phono leads  

  (sold separately).

  Use mircophone socket marked ‘Stereo’.

  Use ‘Mono’ socket for left channel plug.  

  ‘Stereo’ socket for right channel plug.

  Use socket marked ‘Mono’.

  Output will be from both channels.

  Use both input sockets. Microphone

  in ‘Mono’ socket will be amplified on

  the right channel. Microphone in

  ‘Stereo’ socket will be amplified

  on the left channel.

STEREO

MONO

MIC        

PHONO