Fujitsu MAT3300FC 用户手册
2.5 UNIT ATTENTION Condition
C141-C008
2-19
•
Conditions for Reordering:
If commands which are objects of reordering are issued by an INIT which
permits reordering together with a SIMPLE QUEUE.
permits reordering together with a SIMPLE QUEUE.
•
Commands which are Objects of Reordering:
READ, READ EXTENDED, WRITE, WRITE EXTENDED
If the INIT permits command reordering processing, the IDD changes the
command processing order. It is necessary for the INIT to control concerning the
validity of data.
command processing order. It is necessary for the INIT to control concerning the
validity of data.
For details of the control mode page, see 4.1.5, “MODE SELECT EXTENDED
(55)”.
(55)”.
2.5 UNIT ATTENTION Condition
The Unit Attention condition is a function for notifying the INIT asynchronously
of events (status changes) which occur in the TARG or logical unit.
of events (status changes) which occur in the TARG or logical unit.
2.5.1 Generation of the UNIT ATTENTION condition
Events which cause the Unit Attention condition to be generated are any of the
following events.
following events.
(1) When a Power On, LIP (YX), PRLI or TARGET RESET occurs.
If the IDD is reset by a power on, LIP (YX), PRLI or TARGET RESET,
regardless of whether the disk drive is in the ready state or not, the Unit Attention
condition is generated to all the INITs.
regardless of whether the disk drive is in the ready state or not, the Unit Attention
condition is generated to all the INITs.
(2) Mode parameters changed (if changed by another INIT)
If any of the following parameters specified by the MODE SELECT or MODE
SELECT EXTENDED command are changed by any INIT, the Unit Attention
conditions is generated toward all the INITs except the INIT that changed that
parameter.
SELECT EXTENDED command are changed by any INIT, the Unit Attention
conditions is generated toward all the INITs except the INIT that changed that
parameter.
•
Parameters related to the data format (block descriptor, page 3: format
parameter, page 4: any drive parameter)
parameter, page 4: any drive parameter)
•
Parameters related to the cache segment (page 8: Caching parameter, byte 13)
•
Parameters related to command queuing (page A: control mode parameter,
except the RLEC bit in byte 3)
except the RLEC bit in byte 3)
•
Micro code has been changed [=3F-d]