Fujitsu MAT3300FC 用户手册
C141-C008
6-1
CHAPTER 6 Disk Media Management
6.1 Defect
Management
6.2
Disk Media Initialization
6.3
Data Block Verification Methods (Recommended)
6.4
Alternate Block Allocation Processing
In this chapter, disk media defect management methods, treatment methods for
media defects which occur during operation, reinitialization procedures and other
disk media management methods are discussed. Furthermore, see Chapter 3,
"Data Format" in the "Product Manual" concerning details of the data recording
format on the disk media.
media defects which occur during operation, reinitialization procedures and other
disk media management methods are discussed. Furthermore, see Chapter 3,
"Data Format" in the "Product Manual" concerning details of the data recording
format on the disk media.
6.1 Defect Management
(1) Defect lists
Information on the positions of defects in the disk media are managed by the
types of defect list shown below. See the description of the FORMAT UNIT
command (Section 4.3.1) concerning methods for using the defect lists.
types of defect list shown below. See the description of the FORMAT UNIT
command (Section 4.3.1) concerning methods for using the defect lists.
• P List Defect position information at the point when the disk drive was
shipped from the factory is recorded in this list. The defective
portions included in this list are permanent defects, and when the disk
media is initialized, it is necessary that this list be used and alternate
block processing be executed.
portions included in this list are permanent defects, and when the disk
media is initialized, it is necessary that this list be used and alternate
block processing be executed.
• D List This list includes defect position information specified by the INIT in
the FORMAT UNIT command when initializing the disk media.
• C List This list contains information on the positions of defective blocks
detected during the data block Verify operation (Certification) after
initialization by the FORMAT UNIT command. This information is
generated internally by the IDD when the FORMAT UNIT command
is executed.
initialization by the FORMAT UNIT command. This information is
generated internally by the IDD when the FORMAT UNIT command
is executed.
• G List This list is composed from the defective logical data block position
information specified by the INIT in the REASSIGN BLOCKS
command, defective logical data block position information from
alternate blocks which have been allocated by the IDD's auto alternate
block allocation processing, information specified as the D List and
information generated as the C List.
command, defective logical data block position information from
alternate blocks which have been allocated by the IDD's auto alternate
block allocation processing, information specified as the D List and
information generated as the C List.