Behringer Eurolive F1220A F1220A 用户手册

EUROLIVE F1220A User Manual

Use the Monitor/Aux output of a mixer to route the audio signal to the F1220A. 

When using the monitor mix with more loudspeakers, route the audio signal of 

the first F1220A to the next speaker via the LINK output. The volume level of each 

F1220A is adjusted with the respective LEVEL control.

With an F1220A and a microphone, you are able to master small PA tasks with 

minimum effort. The F1220A can also be used with equipment which include 

LINE outputs, such as keyboards, playback devices (for example, CD players) 

and mixers with AUX Send outputs.

Turn the LEVEL control fully to the left.

Connect the signal source to the MIC/LINE input.

Turn on the F1220A.

Turn the LEVEL control slowly to the right until you have reached the desired 

volume level. The CLIP LED helps you in this case. The LED should only light 

up at signal peaks, but shouldn’t glow continuously.

!

!

F1220A

(balanced signal)

(balanced signal)

(balanced signal)

Keyboard 1

Parallel Out

INPUT 1

INPUT 2

INPUT 3

DI400P

(DI Box)

DI400P

(DI Box)

MX400

(Submixer)

LINE

INPUT

OUTPUT

IN

IN

OUT

Parallel Out

Keyboard 2

AUX SEND

Main Mixer

Fig. 3.1: F1220A with two keyboards

If you want to use the same monitor mix on bigger stages, simply increase the 

number of stage monitors. For example, connect two F1220A monitors via the 

LINK output. Either a microphone or line signal can be routed to the first F1220A.

Connect the LINK output of the first loudspeaker with the LINE input of the 

second loudspeaker.

Usually guitar and bass guitar players have amplifiers which allow them to be 

heard when playing on stage—even when a monitor system is being used. 

These amps have enough power to be used on smaller stages. However, it’s quite 

a different matter for the keyboardists because they normally won’t use 

instrument amplifiers.
It is possible to connect a keyboard directly to the F1220A. In case you want to 

hook up two keyboards, use a submixer, such as the MicroMIX MX400, to join 

both signals and then connect the mixer’s output to the LINE input of the F1220A. 

Route the Aux/Monitor signal coming from the main mixer to the submixer so 

that you can hear your band members as well (see fig. 3.1).

A notch filter cancels a narrow frequency band of the signal being used. 

Typical interferences, such as feedback and rumble, are found close to the 

signal and are therefore easily filtered out.
To pinpoint the interfering frequency, activate the filter and slowly turn the 

FREQUENCY control from the left to the right.