Kingston Technology 8GB DDR3-1866MHz Server Premier KVR18E13/8KF 产品宣传页
产品代码
KVR18E13/8KF
KVR18E13/8KF
8GB 2Rx8 1G x 72-Bit PC3-14900
CL13 ECC 240-Pin DIMM
CL13 ECC 240-Pin DIMM
DESCRIPTION
This document describes ValueRAM's 1G x 72-bit (8GB)
DDR3-1866 CL13 SDRAM (Synchronous DRAM) 2Rx8, ECC
memory module, based on eighteen 512M x 8-bit FBGA compo-
nents. The SPD is programmed to JEDEC standard latency
DDR3-1866 timing of 13-13-13 at 1.5V. This 240-pin DIMM
uses gold contact fingers. The electrical and mechanical
specifications are as follows:
FEATURES
•
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
•
VDDQ = 1.5V (1.425V ~ 1.575V)
•
933MHz fCK for 1866Mb/sec/pin
•
8 independent internal bank
•
Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6
•
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
•
8-bit pre-fetch
•
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
•
Bi-directional Differential Data Strobe
•
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
•
On Die Termination using ODT pin
•
On-DIMM thermal sensor (Grade B)
•
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
•
Asynchronous Reset
•
PCB : Height 1.180” (30.00mm), double sided component
Document No. VALUERAM1437-001.A00 05/14/14 Page 1
Memory Module Specifi cations
SPECIFICATIONS
CL(IDD)
13 cycles
Row Cycle Time (tRCmin)
47.125ns (min.)
Refresh to Active/Refresh
260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)
34ns (min.)
Maximum Operating Power
TBD W*
UL Rating
94 V - 0
Operating Temperature
0
o
C to 85
o
C
Storage Temperature
-55
o
C to +100
o
C
*Power will vary depending on the SDRAM used.
Continued >>
SDRAM SUPPORTED
Kingston (F-Die)