Fantec SNT-BA3141-1 2052 产品宣传页
产品代码
2052
D.1--- Reset Switch for buzzer alarm and Overheating LED
When overheating occurs the buzzer alarms (default setting:
60
and the temperature LED returns red meanwhile buzzer is
alarming and LED is blinking). press the Reset Switch to stop the
alarm, and LED goes off.
D.2--- D.5 (HD1 〜 HD4, Power SW and LED: Power on, LED
indicates Green. Orange color blinking for HDD access)
D.6--- Fan sensor LED: LED is indicating Green when it is working.
When fan fail, LED turns Red.
D.7--- Safety Lock
The safety lock safeguards the hard disk in the correct
position and prevent it bouncing out while HDD is working. (see
Picture E)
Picture E
POWER1: 4pin Power connector
POWER2: 15pin Serial ATA Power connector
HD1—HD4: 7pin Serial ATA Signal connector
If your power is not from SATA 15pin
connector, then, use the 4pin power
connector, the 4pin power will automatically
be convert to SATA power. (Note: Can mix
using 4pin and 15pin powers）
lJP1: Temperature setting jumper
lJP3: Extension function jumper
FLEDR: Fan failure detection (red)
FLED+: Fan failure detection (+)
FLEDG: Fan failure detection (green)
RESET: Reset Switch for buzzer alarm and
Overheating LED
TLEDR: Temperature detection (red)
5V+: 5V Power
TLEDG：Temperature detection (green)
GND：Grounded
J8: FAN RPM HIGH(3600rpm) &
LOW(2800rpm) Optional
---Rear View--- (see picture F)
Picture F