Rigol DS2202A 2-channel oscilloscope, Digital Storage oscilloscope, DS2202A 用户手册
产品代码
DS2202A
RIGOL
DS2000A User’s Guide
14-12
Aux Output
Users can set the type of the signal output from the [Trigger Out] connector at the
rear panel.
Press Utility AuxOutput to select the desired output type.
1. TrigOut
After this type is selected, the oscilloscope outputs a signal that can reflect the
current capture rate of the oscilloscope at each trigger. Connect this signal to a
waveform display device, measure the signal frequency and the measurement
result equals the current acquisition rate.
current capture rate of the oscilloscope at each trigger. Connect this signal to a
waveform display device, measure the signal frequency and the measurement
result equals the current acquisition rate.
2. PassFail
After this type is selected, the oscilloscope will output a pulse signal when failed
waveforms are detected. This signal can be connected to other control systems
to conveniently view the test results. The oscilloscope will output a 3.3 V high
level when no failed waveform is detected.
waveforms are detected. This signal can be connected to other control systems
to conveniently view the test results. The oscilloscope will output a 3.3 V high
level when no failed waveform is detected.