Dostmann Electronic Dostmann electronic Temperature Data Logger 5005-0002 数据表
产品代码
5005-0002
LOG10
– Data logger
LOG10
– Data logger
13
12
1.4. Marking
• CE-conformity, EN 12830, EN 13485, Suitability for storage (S) and
• CE-conformity, EN 12830, EN 13485, Suitability for storage (S) and
transportation (T) for food storage and distribution(C), Accuracy classifi-
cation 1 (-30..+70°C), according to EN 13486 we recommend a recalibration
once per year.
cation 1 (-30..+70°C), according to EN 13486 we recommend a recalibration
once per year.
2. Operation
• For configuring the data logger, please install the Software DE-LOG-Graph
on a PC.
2.1 USB-Port
• When the Software Installation has been completed please connect the PC
• When the Software Installation has been completed please connect the PC
with data logger via USB-cable. For detailed information please read the
manual of the DE-LOG-Graph-Software.
manual of the DE-LOG-Graph-Software.
2.2 Panel and display (Fig. 1)
Log10 has a large display, one LED and one button.
A: LCD-display indicates temperature, Low bat-warning, Max-Min-Avg-
Log10 has a large display, one LED and one button.
A: LCD-display indicates temperature, Low bat-warning, Max-Min-Avg-
measurements, status information
B:
Start-Stop-button
C:
LED: red
D: USB-port (with rubber cap)
2.3 Handling the Start-Stop-button
• Depending on the setup configuration, you can start or stop the data log-
• Depending on the setup configuration, you can start or stop the data log-
ger via the Start-Stop-button. You have to press and hold the button for
3 seconds. When it starts, the display indication will switch from STOP to
LOG.
3 seconds. When it starts, the display indication will switch from STOP to
LOG.
1.3 Standard settings / Factory settings
• Note the following default settings of the data logger before first use. By
using the DE-LOG-Graph software, the setting parameter can easily be
changed:
1.
Description: blank (max. 16 characters)
2.
LCD-Snooze mode:
3.
LCD-Snooze after Sec.: 30
4.
Alarm settings for temperature:
-30,0°C 60,0°C
5.
Alarm delay:
□
6.
Alarm cumulation: off
7.
Alarm reset:
8.
Temperature unit: °C
9.
Waiting for manual start:
10. Single use only:
11. Measuring interval: 15 Minutes
12. Cycle memory:
(if the memory is full the oldest measurement will be
overwritten)
= Default
DE_Log10_Anleitung.bel 22.03.2011 10:28 Uhr Seite 12