Nkk Switches A12AP 100mA Miniature Toggle Switch, , 28V Dc/Ac A12AP 数据表

Indicators

Accessories

Supplement

Tactiles

Keylocks

Rotaries

Pushbuttons

Illuminated PB

Slides

Programmable

Rockers

Touch

Tilt

 

A

Toggles

General 

Specifications

Logic Level: 

  0.4VA maximum @ 28V AC/DC maximum

 

  (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V)

 

  Note:  Find additional explanation of operating range in Supplement section.

Contact Resistance:   50 milliohms maximum

Insulation Resistance:  500 megohms minimum @ 500V DC

Dielectric Strength:  500V AC minimum between contacts for 1 minute minimum;

 

  500V AC minimum between contacts & case for 1 minute minimum

Mechanical Life:  100,000 operations minimum for On-None-On & On-Off-On

 

  50,000 operations minimum for other circuits 

Electrical Life:  50,000 operations minimum

 

Nominal Operating Force:  1.47N (momentary); 1.18N (maintained) for .394” (10.0mm) toggles

  2.73N (momentary); 1.84N (maintained) for all other toggles

Contact Timing:  Nonshorting (break-before-make) 

Angle of Throw:    26°  

Toggle:  Glass fiber reinforced polyamide for antistatic; nickel plated brass for all others 

 

Case Housing:  Glass fiber reinforced polyamide 

 

Support Bracket:  Tin plated phosphor bronze

Movable Contact:  Phosphor bronze with gold plating

Stationary Contacts:  Brass with gold plating

 

Terminals:  Brass with gold plating 

 Operating Temperature Range:  –30°C through +85°C (–22°F through +185°F)
 

Humidity:   90 ~ 95% humidity for 240 hours @ 40°C (104°F)

Vibration:  10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range  

 

  & returning in 1 minute; 3 right angled directions for 2 hours

Shock:  50G (490m/s

2

) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)

 

Soldering:   Wave Soldering Recommended.  See Profile A in Supplement section. 

 

  Manual Soldering: See Profile B in Supplement section.

 

Cleaning:  Automated cleaning.  See Cleaning Specifications in Supplement section.

  The A Series toggles have not been tested for UL recognition or CSA certification.

 

  These switches are designed for use in a low-voltage, low-current, logic-level circuit. 

 

  When used as intended in a logic-level circuit, the results do not produce hazardous energy.