CHIPDRIVE CLOUD 4700F 905511 数据表

 

 

This Escape command is used to send data to an initiator device. Prior to using this command, 
the device should have been successfully switched to target mode using 

CNTLESS_P2P_SWITCH_MODES (E9)

. 

 

 

0 

0xEB   

Target Send  

1 

0x00 

RFU 

2 

0x00 

RFU 

3 

0x00 

RFU 

4 

0 - No Chaining 

1 - Chaining  

Chaining byte 

5 

 

Timeout Low Byte 

6 

 

Timeout High Byte 

Offset 7 to 

offset  7+N 

N data bytes 

Bytes to be sent to Initiator device 

 

Once the data bytes are sent successfully, the firmware would indicate if it is ready to send 
more bytes through the chaining byte 

0 

 

RFU 

1 

 

RFU 

2 

 

RFU 

3 

0 – No Chaining 

1 – Chaining  

Chaining 

 

This escape command is used by the application to deselect the target device towards the end 
of P2P communication. 

The deselect response as received from the target will be sent in the response buffer from 
offset 0x00 

Escape code(0xE6)