B B Thermotechnik B & B Thermotechnik CON-SENSW-TF-M10 Temperature Sensor With M10 Thread Temperature sensor pressure-resistant with hex s CON-SENSW-TF-M10 数据表
产品代码
CON-SENSW-TF-M10
DATA SHEET
Technical changes reserved
0141 0316-98 07/2014
0141 0316-98 07/2014
Setting the switching point
The switching point setting for analog input „SETP ANA“ is done by the
preset potentiometer at the right edge of the PCB. The setting is done
by comparative measurement at the desired switching point.
The range of setting is right from around –40 °C (left limit on the poten-
tiometer, i.e. counter clockwise direction) to about 100 °C (right limit).
The middle point of the potentiometer is at approx. 25 °C.
The switching hysteresis (difference between ON and OFF switching
point) can be adjusted by the preset potentiometer “HYS ANA“. The
setting is to be done with a suitable screw driver.
preset potentiometer at the right edge of the PCB. The setting is done
by comparative measurement at the desired switching point.
The range of setting is right from around –40 °C (left limit on the poten-
tiometer, i.e. counter clockwise direction) to about 100 °C (right limit).
The middle point of the potentiometer is at approx. 25 °C.
The switching hysteresis (difference between ON and OFF switching
point) can be adjusted by the preset potentiometer “HYS ANA“. The
setting is to be done with a suitable screw driver.
Time delay Setting
Finally, adjustment of time delay setting is done by placing the jumper
plug in the desired position on the contact strip “TIMER”. With this, the
configuration is complete and the device is ready for use.
plug in the desired position on the contact strip “TIMER”. With this, the
configuration is complete and the device is ready for use.
Pressure resistant temperature probe for
sensor control module
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
3 / 3