Beha Amprobe LM-100 Lux-Meter, illumination measuring device, Brightness meter, 0 - 200000 lx 3052348 用户手册
产品代码
3052348
7
Storage:
-10 °C to 50 °C, 0 to 70 %Rh.
power Supply:
9V nedA 1604, ieC 6f22, JiS 006p battery
Battery life:
200 hours
Auto power off:
approx 6 min
dimension (Base):
130 x 63 x 38 mm (5.1 x 2.5 x 1.5”)
dimension (Sensor):
80 x 55 x 29 mm (3.2 x 2.2 x 1.1”)
weight:
220 g (.48 lb.) include battery
�
-eMC: en61326-1 This product complies with requirements of the
following european Community directives: 89/336/eeC (electromagnetic
Compatibility) and 73/23/eeC (Low Voltage) as amended by 93/68/eeC (Ce
Marking). however, electrical noise or intense electromagnetic fields in the
vicinity of the equipment may disturb the measurement circuit. Measuring
instruments will also respond to unwanted signals that may be present within
the measurement circuit. Users should exercise care and take appropriate
precautions to avoid misleading results when making measurements in the
presence of electronic interference.
Illumination:
Compatibility) and 73/23/eeC (Low Voltage) as amended by 93/68/eeC (Ce
Marking). however, electrical noise or intense electromagnetic fields in the
vicinity of the equipment may disturb the measurement circuit. Measuring
instruments will also respond to unwanted signals that may be present within
the measurement circuit. Users should exercise care and take appropriate
precautions to avoid misleading results when making measurements in the
presence of electronic interference.
Illumination:
Measuring Range:
200, 2000, 20000, 200000 Lux
20, 200, 2000, 20000 foot candles
Accuracy:
± 5 % (Calibrated to standard
incandescent lamp at 2856 K)
incandescent lamp at 2856 K)
operating error < 10%
MAINtENANCE ANd REPAIR
if there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.
if there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem.
Check the battery. Replace the battery immediately when the symbol
1.
“�” appears on the LCd.
Review the operating instructions for possible mistakes in operating
Review the operating instructions for possible mistakes in operating
2.
procedure.
except for the replacement of the battery, repair of the meter should be
performed only by a factory Authorized Service Center or by other qualified
instrument service personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly with a soft cloth and
allow to dry completely before using. do not use aromatic hydrocarbons or
chlorinated solvents for cleaning.
performed only by a factory Authorized Service Center or by other qualified
instrument service personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly with a soft cloth and
allow to dry completely before using. do not use aromatic hydrocarbons or
chlorinated solvents for cleaning.