Futaba 6J F4103 数据表

appears on screen.

4) The LCD screen will contain the pitch curve point indication (left side of screen), as well as the current 

pitch curve value, expressed as a percentage of travel, on the right side of the display. 

Note: Point 1 is shown initially which is throttle stick all the way downward (slow) 

position.  Point 5 is throttle stick all the way upward (hi) position.  

Press the DATA INPUT lever upward to increase the percentage of servo travel for 

the respective point on the pitch curve.  Press the DATA INPUT lever downward to 
decrease the percentage of servo travel for the respective point on the pitch curve. 

5) Press the SELECT button one time to bring up the point two (2) pitch curve adjustments.  Again, use the 

DATA INPUT lever to adjust the values accordingly.

6) Repeat the previous steps to set the normal pitch curve point values for the remaining three (3) points.

7) Press and hold the END button to exit the programming mode.

Throttle hold function is typically used for autorotations where only pitch control is used to make a descent 
#;  #    '# #=# 
  ##$!'# =!# ' 
#!  # ";#  ! + 
$]›]š#! 

Note: The collective servo remains active to allow for pitch inputs during the descent of the helicopter.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.  An audible double beep will be heard 

and the default screen will change accordingly.

3) Press either the MODE key OR the END key to scroll through the function menus. 

Continue pressing the MODE or END key until the throttle hold (HOLD) menu 
appears on screen. 

Š~;      ’ˆ  #    # #   +    +   = 

INH.  Activate the throttle hold by pressing and holding the DATA INPUT lever upward.  The INH should