Carson FAHRTREGLER DRAGSTER PRIME WATERPROOF 500909169 数据表

With the dead band setting you can adjust the speed controller to the transmitter 
being used by changing the transition from forward drive to brake action. Level 
1 means a narrower transition area which requires particularly finely tuned 
transmitting signals. Simple transmitters are sufficient for the wider transition 
area at Level 5. 

Flashing 
frequency

1

2

3

4

5

Dead  Band  (%)

2

3

4

5

6

• 

Press the SET button down until the blue LED light up 5 times.
Release the SET button again.

• 

The red LED start flashing. This shows that you are in the mode for setting the 
dead band delay time.

• 

Press the SET button repeatedly until you reach the required setting.  
The red LED flash at the next highest speed.

• 

By repeatedly pressing briefly on the SET button you can scroll through the 
settings.

• 

When you reach the required setting, hold down the SET button for approx. 
2 seconds; the setting is stored.

• 

Once you have stored the setting, the red and blue LEDs flashes alternate 3 
times to show that you are leaving the programming mode. Switch controller 
off and on again to activate the selected settings.

• 

If you do not press the SET button for more than 10 seconds the 
controller reverts to the last setting and is ready for use again.

Blue LED

Red LED