DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表
产品代码
Inspire 1 with 2RC
12
©
2014 DJI. All Rights Reserved.
Aircraft
Flight Status Indicator
The INSPIRE 1 comes with the Front LED, Rear LED and Aircraft Status Indicator. The positions of these
LEDs are shown in the figure below:
The Front and Rear LED show the orientation of the aircraft. The Front LED displays solid red and the
Rear LED displays solid green.
Aircraft Status Indicator shows the system status of the flight controller. Refer to the table below for more
information about the Aircraft Status Indicator:
Aircraft
Flight Controller
The Inspire 1’s flight controller is based on DJI flight controller with several enhancements such as new
flight mode and new safe mode. Three safe modes are available: Failsafe, Return Home and Dynamic
Home Point. These features ensure the safe return of your aircraft if the control signal is lost. A flight
recorder stores crucial flight data for each flight.
Flight Mode
Three flight modes are available. The details of each flight mode are found in the section below:
P mode (Positioning) : P mode works best when GPS signal is strong. There are three different states of P
mode, which will be automatically selected by the Inspire 1 depending on GPS signal strength and Vision
Positioning sensors:
P-GPS: GPS and Vision Positioning both are available, and the aircraft is using GPS for positioning.
P-OPTI: Vision Positioning is available but the GPS signal is not. Aircraft is using only Vision
Positioning for hovering
P-ATTI: Neither GPS or Vision Positioning available, aircraft is using only its barometer for positioning,
so only altitude is controlled.
A mode (Attitude): The GPS and Vision Positioning System is not used for holding position. The aircraft
only uses its barometer to maintain altitude. If it is still receiving a GPS signal, the aircraft can automatically
return home if the Remote Controller signal is lost and if the Home Point has been recorded successfully.
F mode (Function): Intelligent Orientation Control (IOC) is activated in this mode. For more information
about IOC, refer to the IOC in Appendix.
Use the Flight Controller mode switch to change the flight mode of the aircraft, refer to the “Flight
Front LED
Rear LED
Aircraft Status Indicator