DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表

产品代码

Inspire 1 with 2RC

Appendix

INSPIRE 1

User Manual

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Changes or modifications not expressly roved by the party responsible for compliance could void the

user's authority to operate the equipment.

Compliance Information

FCC Warning Message

Any Changes or modifications not expressly roved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator&

the update is in progress. The Status LED on the remote controller will show a solid green light and the

beeping sound will stop when the upgrade is complete. The Status LED on the remote controller will

show a solid red light if the upgrade fails. In this case, try the update again.

Updating Intelligent Flight Battery Firmware

The Intelligent Flight Battery’s firmware is updated during the aircraft firmware update process. Simply

keep the update package files on your SD card and update the Intelligent Flight Battery firmware if

prompted in the DJI Pilot app. The update will start automatically if the aircraft is not connected to the DJI

Pilot app after power cycling the aircraft.

Do not perform firmware update while the aircraft is still flying in the air. Only carry out firmware

update when the aircraft is landed.

Be sure to update the remote controller’s firmware to the latest version after you upgrade the aircraft’s

firmware.

The remote controller may become unlinked from the aircraft after updating. Re-link the remote

controller and aircraft.

Confirm the update results according to the gimbal sounds. It is normal for the aircraft to sound or the

LED to blink during the update process. The on-screen rate of progress is for reference only.

Ensure there is only one firmware package file stored on your SD card.

Only storage devices that are formatted for FAT32 and exFAT file systems are supported for aircraft

and remote controller firmware updates.

Delete any automatically generated txt files (xxx_GS.TXT) in the SD card when updating multiple

remote controllers.