DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC 数据表

产品代码

Inspire 1 with 2RC

Product Profile

INSPIRE 1

User Manual

Assemble the Aircraft

Unlocking Travel Mode

The aircraft is in Travel Mode during delivery. Follow these steps to change it to Landing Mode before

your first flight:

1. Insert the Intelligent Flight Battery into the battery compartment.

2. Power on the Remote Controller and the Intelligent Flight Battery.

3. Toggle the Transformation Switch up and down at least four times.

4. Power off the aircraft.

Battery must be fully charged before using it for the first time. Refer to "Charging the Intelligent

If you have purchased the dual remote controller version, you must use the Master remote

section for more infromation about Master remote controller.

Be sure to remove the gimbal from the aircraft before switch from Landing Mode to Travel Mode.

Place the aircraft on the smooth and reflective surface (e.g. table or tile) before switching between

the travel modes to the landing mode. Do not place the aircraft on the rough and sound-absorbing

surface (e.g. carpet) before switching between the travel modes and landing mode.

Installing Gimbal and Camera

1. Remove Gimbal Cover.

2. Rotate the Gimbal Lock to the unlocked position (to the right when facing the nose of the aircraft).

3. Insert the gimbal by aligning the white mark on the Gimbal.

4. Rotate the Gimbal Lock back into the locked position.

Ensure the Micro-SD card is correctly inserted into the camera.

Travel Mode

Toggle×4

Landing Mode

Locked

Gimbal Connector

Mounting Place

Gimbal Lock

Gimbal Cover