Insect O Cutor UPLIGHTER INSEKTENFALLE 15 W, WEIß 301W 数据表
产品代码
301W
MAINTENANCE
Always SWITCH OFF and DISCONNECT the electrical supply before attempting
any work on the unit. The unit is designed to a high standard and built to give
many years of trouble free service. To ensure that the unit continues to perform
as designed the unit should be serviced at least twice per year. One minor
service to clean the unit and check the electrical systems. One major service to
change the attractant lamps, in addition to cleaning and checking the electrical
systems.
REPLACING THE GLUEBOARD
The glueboard is located behind the front cover, to remove it simply pull it
upwards and out of the unit. To replace the glue board remove the protective film
that covers the adhesive then slide it back into the unit.
REPLACING THE LAMP
Switch off the electrical supply before removing the front cover. The front cover is
held in position by two cross head screws located on each side near the top of
the unit. To remove the cover, unscrew both of the screws, whilst holding the
cover to prevent it from falling. To remove the lamp, simply pull it towards the left
until it is free from the lampholder. Replace with a new lamp by pushing it into the
lampholder until it snaps into position.
CLEANING
The body of the unit should only need occasional wiping over with a damp cloth
and mild liquid detergent.
Insect-O-Cutor is a Trade Mark of P+L Systems Ltd.
Always SWITCH OFF and DISCONNECT the electrical supply before attempting
any work on the unit. The unit is designed to a high standard and built to give
many years of trouble free service. To ensure that the unit continues to perform
as designed the unit should be serviced at least twice per year. One minor
service to clean the unit and check the electrical systems. One major service to
change the attractant lamps, in addition to cleaning and checking the electrical
systems.
REPLACING THE GLUEBOARD
The glueboard is located behind the front cover, to remove it simply pull it
upwards and out of the unit. To replace the glue board remove the protective film
that covers the adhesive then slide it back into the unit.
REPLACING THE LAMP
Switch off the electrical supply before removing the front cover. The front cover is
held in position by two cross head screws located on each side near the top of
the unit. To remove the cover, unscrew both of the screws, whilst holding the
cover to prevent it from falling. To remove the lamp, simply pull it towards the left
until it is free from the lampholder. Replace with a new lamp by pushing it into the
lampholder until it snaps into position.
CLEANING
The body of the unit should only need occasional wiping over with a damp cloth
and mild liquid detergent.
Insect-O-Cutor is a Trade Mark of P+L Systems Ltd.