Texas Instruments Evaluation Board for the LM2842 LM2842XMK-ADJEV/NOPB LM2842XMK-ADJEV/NOPB 数据表
产品代码
LM2842XMK-ADJEV/NOPB
User's Guide
SNVA377D – March 2009 – Revised April 2013
AN-1908 LM2842 Evaluation Board
1
Introduction
The LM2842 is a PWM DC/DC buck (step-down) regulator. With a wide input range from 4.5V to 42V, it is
suitable for a wide range of applications from automotive to power conditioning from unregulated sources.
The LM2842 evaluation board is designed to provide the design engineer with a fully functional power
converter based on the buck topology to evaluate the LM2842 series of buck regulators. The evaluation
board comes populated with the LM2842XMK-ADJL but can easily be modified to accommodate any of
the LM2842 regulator ICs.
suitable for a wide range of applications from automotive to power conditioning from unregulated sources.
The LM2842 evaluation board is designed to provide the design engineer with a fully functional power
converter based on the buck topology to evaluate the LM2842 series of buck regulators. The evaluation
board comes populated with the LM2842XMK-ADJL but can easily be modified to accommodate any of
the LM2842 regulator ICs.
2
Features
•
4.5V to 42V Input Voltage Range
•
3.3V Output Voltage
•
Up to 600 mA Output Current
•
89% Efficiency at 300 mA
•
Switching Frequency of 550 kHz
•
Frequency Foldback Current Limit of 1A
•
Internal Compensation
3
Shutdown Operation
The evaluation board includes a 3 pin header and a jumper to select whether the device is on or off.
Placing the jumper in the "ON" position ties SHDN to VIN and enables the device. Placing the jumper in
the "OFF" position ties SHDN to GND and disables the device. The jumper may be removed and a logic
signal may be applied to the center pin to test startup and shutdown of the device.
Placing the jumper in the "ON" position ties SHDN to VIN and enables the device. Placing the jumper in
the "OFF" position ties SHDN to GND and disables the device. The jumper may be removed and a logic
signal may be applied to the center pin to test startup and shutdown of the device.
4
Adjusting the Output Voltage
The output voltage can be changed from 3.3V to another voltage by adjusting the feedback resistors using
the following equation:
the following equation:
V
OUT
= V
FB
(1+(RFB1/RFB2))
(1)
Where V
FB
is 0.76V.
All trademarks are the property of their respective owners.
1
SNVA377D – March 2009 – Revised April 2013
AN-1908 LM2842 Evaluation Board
Copyright © 2009–2013, Texas Instruments Incorporated