Texas Instruments TPS2410 Evaluation Module TPS2410EVM TPS2410EVM 数据表
产品代码
TPS2410EVM
MOSFET Configurations
2
MOSFET Configurations
The TPS2410 EVM is supplied with IRL3713 MOSFETS. These MOSFETs can be replaced with user
selected parts if desired as there are alternative MOSFET footprints that accept N-channel parts in
D2PACK, DPACK, and SOIC packages. The schematic is shown in
selected parts if desired as there are alternative MOSFET footprints that accept N-channel parts in
D2PACK, DPACK, and SOIC packages. The schematic is shown in
The MOSFETs are configured to operate as singles with only Q6 and Q13 populated as supplied. They
may be configured to operate in parallel on the PS1 channel by populating Q6 and Q5 and shorting drain
to source on Q4. Similarly, for parallel operation on the PS2 channel, populate Q13 and Q12 and short
drain to source on Q11. MOSFETs can be configured back-to-back by populating only Q4 and Q5 on
channel 1, and Q12 and Q11 on channel 2.
may be configured to operate in parallel on the PS1 channel by populating Q6 and Q5 and shorting drain
to source on Q4. Similarly, for parallel operation on the PS2 channel, populate Q13 and Q12 and short
drain to source on Q11. MOSFETs can be configured back-to-back by populating only Q4 and Q5 on
channel 1, and Q12 and Q11 on channel 2.
In single or parallel configurations, the body diode of the MOSFET limits V
AC
to 0.7 V. For back to back
MOSFETs, there could be a danger of exceeding the V
AC
operating maximum 5 V. The V
AC
protect circuit
is a low powered FET that is turned on when V
AC
approaches the maximum.
3
LED Indicators
Each channel has LED indicators for fault (FLTB), gate status (STAT), and power good (PG).
summarizes the indicators. Each is indicator is labeled on the circuit board for easy reference.
Table 1. LED Indicators
Indicator
Channel 1
Channel 2
LED On
Fault (FLTB)
D3
D8
Fault = on
Gate Status (STAT)
D2
D7
Bad gate = on
Power Good (PG)
D1
D6
Power good = on
3.1
User Circuits
There are two sections of the circuit board with plated through holes for user defined circuits.
3.2
Materials Needed
–
TI Supplied
•
TPS2410 evaluation module
•
TPS2410 reference design documentation
•
TPS2410 data sheet
3.3
User Supplied
•
2
–
power supplies for wire-OR to load, up to 25 A
•
1
–
5-V power supply to supply EVM
•
Power supply cables
•
Load
–
active load, power resistors or actual load
•
Oscilloscope
•
Current probe
•
Differential probe
4
TPS2410 EVM (HPA204)
SLVU181A
–
October 2006
–
Revised February 2012
Copyright
©
2006
–
2012, Texas Instruments Incorporated