Texas Instruments TPS659121 PMU for Processor Power Evaluation Module TPS659121EVM-081 TPS659121EVM-081 数据表
产品代码
TPS659121EVM-081
PRODUCTPREVIEW
SWCS078 – JUNE 2012
PMU FOR PROCESSOR POWER
Check for Samples:
1
INTRODUCTION
1.1
Features
1
– Multiplexed with GPIOs
• 4 Step-Down Converters:
– Up to 20mA per Current Sink
– V
IN
Range From 2.7V to 5.5V
• Thermal Monitoring
– Power Save Mode at Light Load Current
– High Temperature Warning
– Output Voltage Accuracy in PWM Mode ±2%
– Thermal Shutdown
– Typical 26
μ
A Quiescent Current per
Converter
• Bypass Switch
– Dynamic Voltage Scaling
– Used with DCDC4 in Applications Powering
an RF-PA
– 100% Duty Cycle for Lowest Dropout
– As Supply Switch for e.g. SD cards
• 10 LDOs:
• Interface
– 8 General Purpose LDOs
– I
2
C Interface
– Output Voltage Range 0.8V to 3.3V
– Power I
2
C Interface for Dynamic Voltage
– 2 Low Noise RF-LDOs
Scaling
– Output Voltage Range 1.6V to 3.3V
– SPI
– 32
μ
A Quiescent Current
• 32kHz RC Oscillator
– Pre-Regulation Support by Separate Power
• Undervoltage Lockout and Battery Fault
Inputs
Comparator
– ECO mode
• Long Button-Press Detection
– V
IN
Range of LDOs:
• Flexible Power-Up and Power-Down
•
1.8V to 3.6V or
Sequencing
•
3.0V to 5.5V, respectively
• 3.6mm x 3.6mm WCSP Package with 0.4mm
• 3 LED Outputs:
pitch
– Internal Dimming Using I2C
1.2
Applications
•
Data cards
•
Smartphones
1.3
Description
The TPS659121 device provides four configurable step-down converters with up to 2.5A output current for
memory, processor core, I/O, or pre-regulation of LDOs. It also contains 10 LDO regulators for external
usage which can be supplied from either a battery or a pre-regulated supply. Power-up/power-down
controller is configurable and can support any power-up/power-down sequences (OTP based). The
TPS659121 integrates a 32 kHz RC Oscillator to sequence all resources during Power up / down. All
LDOs and DCDC converters can be controlled by I2C/SPI interface or Basic ENABLE Balls. In addition,
an Independent automatic Voltage Scaling interface allows transitioning DCDC to different voltage by I2C
or basic Roof/Floor Control. 3 RGB LED with advanced dimming feature are integrated inside the device.
GPIO functionality is multiplexed with LED/ENBLE/SPI when not used. Each GPIO can be configured as
part of the Power up sequence to control external resources. One Sleep pin enables power mode control
between ACTIVE and pre-programmed SLEEP mode for power optimization. For system control, the
TPS659121 has 1 comparator for system state management. The TPS659121 comes in a 9 ball x 9 ball
WCSP package (3.6mm x 3.6mm) with a 0.4mm pitch. To request a full data sheet, please send an email
to:
memory, processor core, I/O, or pre-regulation of LDOs. It also contains 10 LDO regulators for external
usage which can be supplied from either a battery or a pre-regulated supply. Power-up/power-down
controller is configurable and can support any power-up/power-down sequences (OTP based). The
TPS659121 integrates a 32 kHz RC Oscillator to sequence all resources during Power up / down. All
LDOs and DCDC converters can be controlled by I2C/SPI interface or Basic ENABLE Balls. In addition,
an Independent automatic Voltage Scaling interface allows transitioning DCDC to different voltage by I2C
or basic Roof/Floor Control. 3 RGB LED with advanced dimming feature are integrated inside the device.
GPIO functionality is multiplexed with LED/ENBLE/SPI when not used. Each GPIO can be configured as
part of the Power up sequence to control external resources. One Sleep pin enables power mode control
between ACTIVE and pre-programmed SLEEP mode for power optimization. For system control, the
TPS659121 has 1 comparator for system state management. The TPS659121 comes in a 9 ball x 9 ball
WCSP package (3.6mm x 3.6mm) with a 0.4mm pitch. To request a full data sheet, please send an email
to:
.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCT PREVIEW information concerns products in the formative or design phase of
Copyright © 2012, Texas Instruments Incorporated
development. Characteristic data and other specifications are design goals. Texas
Instruments reserves the right to change or discontinue these products without notice.
Instruments reserves the right to change or discontinue these products without notice.