Texas Instruments AFE5808A Evaluation Module AFE5808AEVM AFE5808AEVM 数据表
产品代码
AFE5808AEVM
Software Installation and Operation
Figure 1. AFE5808/08AEVM Basic Configuration
1. P1
–
Power supplies connector.
2. JP1, JP2, and JP3 are set to enable 3.3-V, 1.8-V, and 5-V power supplies to device.
3. JP9: enables onboard CMOS clock.
4. JP10: Power supply for onboard CMOS clock oscillator.
5. JP15: Enables onboard VCNT.
6. JP31 always set as
.
3
Software Installation and Operation
The AFE5808/08AEVM GUI (
) can be downloaded from the TI Web site. Follow the directions in
the Read Me First.pdf file to install the GUI and device driver
4
Test Setup
Two EVMs are required to evaluate the AFE5808/08A device. The following illustration shows the exact
setup of these two boards and external connectors. For the default configuration as shown in
setup of these two boards and external connectors. For the default configuration as shown in
, it is
unnecessary to have an external sampling clock and external Vcntl supply. The onboard CMOS clock and
onboard Vcntl are used.
onboard Vcntl are used.
3
SLOU328A
–
November 2011
–
Revised December 2011
AFE5808/08AEVM (Rev E) Evaluation Module
Copyright
©
2011, Texas Instruments Incorporated