Microchip Technology MA160014 数据表
PIC18(L)F2X/4XK22
DS41412F-page 326
2010-2012 Microchip Technology Inc.
EXAMPLE 19-2:
CURRENT CALIBRATION ROUTINE
#include "p18cxxx.h"
#define COUNT 500 //@ 8MHz = 125uS.
#define DELAY for(i=0;i<COUNT;i++)
#define RCAL .027 //R value is 4200000 (4.2M)
//scaled so that result is in
//1/100th of uA
#define ADSCALE 1023 //for unsigned conversion 10 sig bits
#define ADREF 3.3 //Vdd connected to A/D Vr+
int main(void)
{
int i;
int j = 0; //index for loop
unsigned int Vread = 0;
double VTot = 0;
float Vavg=0, Vcal=0, CTMUISrc = 0; //float values stored for calcs
//assume CTMU and A/D have been set up correctly
//see Example 25-1 for CTMU & A/D setup
setup();
CTMUCONHbits.CTMUEN = 1; //Enable the CTMU
CTMUCONLbits.EDG1STAT = 0; // Set Edge status bits to zero
CTMUCONLbits.EDG2STAT = 0;
for(j=0;j<10;j++)
{
CTMUCONHbits.IDISSEN = 1; //drain charge on the circuit
DELAY; //wait 125us
CTMUCONHbits.IDISSEN = 0; //end drain of circuit
CTMUCONLbits.EDG1STAT = 1; //Begin charging the circuit
//using CTMU current source
DELAY; //wait for 125us
CTMUCONLbits.EDG1STAT = 0; //Stop charging circuit
PIR1bits.ADIF = 0; //make sure A/D Int not set
ADCON0bits.GO=1; //and begin A/D conv.
while(!PIR1bits.ADIF); //Wait for A/D convert complete
Vread = ADRES; //Get the value from the A/D
PIR1bits.ADIF = 0; //Clear A/D Interrupt Flag
VTot += Vread; //Add the reading to the total
}
Vavg = (float)(VTot/10.000); //Average of 10 readings
Vcal = (float)(Vavg/ADSCALE*ADREF);
CTMUISrc = Vcal/RCAL; //CTMUISrc is in 1/100ths of uA
}