Samson Stage 166 Wirless Microphone SWV166SHT6U 数据表

Stage v166: Handheld Wireless System

3.  While holding the upper section of the 

HT6 transmitter, rotate the bottom section 

and slide down to expose the battery 

compartment.  

Insert a standard 9-volt alkaline battery, being 

sure to follow the plus and minus polarity 

markings.   

 

 

 

 

 

 

 

 

4.  Turn on the HT6 transmitter by sliding the POWER switch 

to the right, and replace the bottom section.

 

 

 

 

 

 

5.  Place the SR166 receiver where it will be used (the general rule of thumb is to maintain “line 

of sight” between the receiver and transmitters so that the person(s) using the transmitter can 

see the receiver). Turn on the power of the SR166 receiver. 

 

6.  Turn on the connected amplifier and/

or mixer, but keep its volume all the 

way down.  Next, make sure that your 

transmitter is un-muted by setting 

its Audio switch to ON.  Then, set the 

Volume Control knob on the SR166 

fully clockwise; this is unity gain. 

Speak or sing into the mic at a normal 

performance level while slowly raising 

the volume of your amplifier/mixer until 

the desired level is reached.  

1. Plugging the receiver into the wall.

2. Plugging the receiver into a mixer using 1/4" - 1/4" cable.

4. Plugging the receiver into a Karaoke machine using 1/4" - 1/4" cable.