Freescale Semiconductor Demonstration Board for Freescale MC9S12XHY256 Microcontroller DEMO9S12XHY256 DEMO9S12XHY256 用户手册

288

Freescale Semiconductor

The internal reset of the MCU remains asserted while the reset generator completes the 192 SYSCLK long
reset sequence. In case the RESET pin is externally driven low for more than these 192 SYSCLK cycles
(External Reset), the internal reset remains asserted longer.

The S12XECRG generates a Clock Monitor Reset in case all of the following conditions are true:

•

Clock monitor is enabled (CME = 1)

•

Loss of clock is detected

•

Self-Clock Mode is disabled (SCME = 0).

The reset event asynchronously forces the configuration registers to their default settings. In detail the
CME and the SCME are reset to logical ‘1’ (which changes the state of the SCME bit. As a consequence
the S12XECRG immediately enters Self Clock Mode and starts its internal reset sequence. In parallel the
clock quality check starts. As soon as clock quality check indicates a valid Oscillator Clock the
S12XECRG switches to OSCCLK and leaves Self Clock Mode. Since the clock quality checker is running
in parallel to the reset generator, the S12XECRG may leave Self Clock Mode while still completing the
internal reset sequence.

When COP is enabled, the S12XECRG expects sequential write of $55 and $AA (in this order) to the
ARMCOP register during the selected time-out period. Once this is done, the COP time-out period restarts.
If the program fails to do this the S12XECRG will generate a reset.

The on-chip voltage regulator detects when V

DD

to the MCU has reached a certain level and asserts power

on reset or low voltage reset or both. As soon as a power on reset or low voltage reset is triggered the

) (

) (

)

(

)

)

(

(