Redpitaya RED PITAYA, OPEN SOURCE LAB RED Pitaya V 1.1 数据表
产品代码
RED Pitaya V 1.1
11
Uncomment the
iface eth0 inet dhcp
line.
Comment the lines below including
iface eth0 inet static.
# Red Pitaya network configuration
#
###########################
# lo: Loopback interface #
###########################
auto lo
iface lo inet loopback
######################################
# eth0: Wired Ethernet - 1000Base-T #
######################################
#
# Uncomment only one: dynamic or static configuration.
#
# Dynamic (DHCP) IP address
iface eth0 inet dhcp
udhcpc_opts -t7 -T3
# Static IP address
#iface eth0 inet static
# address 192.168.1.101
# netmask 255.255.255.0
# gateway 192.168.1.1
################################
# wlan0: Wireless USB adapter #
################################
auto wlan0
iface wlan0 inet dhcp
pre-up wpa_supplicant -B -D wext -i wlan0 -c
/opt/etc/network/wpa_supplicant.conf
post-down killall -q wpa_supplicant
udhcpc_opts -t7 -T3
#
###########################
# lo: Loopback interface #
###########################
auto lo
iface lo inet loopback
######################################
# eth0: Wired Ethernet - 1000Base-T #
######################################
#
# Uncomment only one: dynamic or static configuration.
#
# Dynamic (DHCP) IP address
iface eth0 inet dhcp
udhcpc_opts -t7 -T3
# Static IP address
#iface eth0 inet static
# address 192.168.1.101
# netmask 255.255.255.0
# gateway 192.168.1.1
################################
# wlan0: Wireless USB adapter #
################################
auto wlan0
iface wlan0 inet dhcp
pre-up wpa_supplicant -B -D wext -i wlan0 -c
/opt/etc/network/wpa_supplicant.conf
post-down killall -q wpa_supplicant
udhcpc_opts -t7 -T3
Save the file and plug it into Red Pitaya before powering it on.
3.5 Power on
To power ON your Red Pitaya, follow the sequence of these steps exactly:
Step 1:
Place your Red Pitaya on a firm flat surface in a well ventilated environment.
Step 2:
Make sure the Micro SD card is inserted to Red Pitaya.
Step 3:
Plug in the network cable.
Step 4:
If required, plug in the USB cable for console connection.
Step 5:
Connect the power cable and check the status of LED diodes: Blue (D) and Green (P)
LED diodes should be lit. The Orange LED 0 should blink.