Intel D915PCML mATX 915P DDR2-533 LGA775 BOXD915PCML 用户手册
产品代码
BOXD915PCML
Technical Reference
71
2.9 Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
Figure 23 shows the location of the jumper block on the D915PCY board. (The jumper is in the
same location on the D915PCM board.) The jumper block determines the BIOS Setup program’s
mode. Table 36 describes the jumper settings for the three modes: normal, configure, and recovery.
When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the
processor version and the microcode version in the BIOS and reports if the two match.
same location on the D915PCM board.) The jumper block determines the BIOS Setup program’s
mode. Table 36 describes the jumper settings for the three modes: normal, configure, and recovery.
When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the
processor version and the microcode version in the BIOS and reports if the two match.
OM17061
3
1
J8J4
Figure 23. Location of the Jumper Block
Table 36.
BIOS Setup Configuration Jumper Settings
Function/Mode
Jumper Setting
Configuration
Normal
1-2
1
3
The BIOS uses current configuration information and
passwords for booting.
passwords for booting.
Configure
2-3
1
3
After the POST runs, Setup runs automatically. The
maintenance menu is displayed.
maintenance menu is displayed.
Recovery
None
1
3
The BIOS attempts to recover the BIOS configuration. A
recovery diskette is required.
recovery diskette is required.