Atmel MCU Evaluation Kit AT32UC3L-EK AT32UC3L-EK 数据表
产品代码
AT32UC3L-EK
18
Atmel AVR32025
32150B-AVR-03/12
Table 3-11. Conflict conditions with the DataFlash.
QFP48 pin
GPIO
DataFlash signal Conflict conditions
28 PA04
DataFlash
SO
If the WLESS J8 connector is configured with
a jumper on J44.2-4, signal activities over J8.2
will conflict with the DataFlash SO signal
a jumper on J44.2-4, signal activities over J8.2
will conflict with the DataFlash SO signal
12 PA05
If the WLESS J8 connector is configured with
a jumper on J44.1-3, signal activities over J8.1
will conflict with the DataFlash SI signal
a jumper on J44.1-3, signal activities over J8.1
will conflict with the DataFlash SI signal
To summarize, the Atmel DataFlash cannot be used when using an external module
on the WLESS connector configured with a jumper on J44.2-4 and/or with a jumper
on J44.1-3.
on the WLESS connector configured with a jumper on J44.2-4 and/or with a jumper
on J44.1-3.
3.4.4.2 Test points
Two test points covering the DataFlash have been placed on the Atmel AT32UC3L-
EK for the verification of important signals.
EK for the verification of important signals.
Table 3-12. DataFlash test points.
Designation Feature
TP13 DataFlash
#CS
TP14 DataFlash
#WP
To locate the test points mentioned here above, use the assembly top/bottom views
provided in Section
provided in Section
,
3.5 RTC
The RTC block on the AT32UC3L-EK provides a 32kHz oscillating crystal to the
Atmel AT32UC3L064.
Atmel AT32UC3L064.
3.5.1 Overview
Figure 3-12. AT32UC3L-EK RTC logical view.
The AT32UC3L-EK contains a 32kHz crystal connected to the AT32UC3L064.