Mikroelektronika MikroE Development Kits MIKROE-1204 数据表

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS

™

 socket. Make sure to align the 

cut in the lower-right part of the board 
with the markings on the silkscreen at 
the mikroBUS

™

 socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

USB SPI 

click

Before using your click board

™

, make sure 

to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

USB SPI click Manual

0 100000 021248

USB SPI Click

™

 with it’s 

 IC’s gives 

additional SPI serial communication via 
USB cable.

 

The 

IC contains 256 

Bytes of user EEPROM, 128 Byte buffer to 
handle data (64 byte transmit and 64-byte 
receive) and nine general purpose I/O pins. 
The board contains 12 MHz crystal oscillator 
which provides external clock

 

waveform for 

 IC as well as LED diode which 

indicates SPI traffic.  

USB SPI Click

™

 is an accessory board in 

™

 form factor. It’s a compact 

and easy solution for adding SPI serial 
communication via USB cable. It features 

 USB-to-SPI protocol converter 

with GPIO as well as USB MINI B connector. 
USB SPI Click

™

 communicates with target 

board via SPI interface as a master device. 
The board is designed to use 3.3V or 5V 
power supply.

 

It has a LED diode (GREEN) 

that indicates the presence of power supply.