Mikroelektronika MikroE Development Kits MIKROE-971 数据表
产品代码
MIKROE-971
1. Introduction
ETH Click is an accessory board in
mikroBus™
form factor. It features
ENC28J60
, a 28-pin,
10BASE-T stand alone Ethernet Controller
with an on-board MAC & PHY, 8K Bytes of
Buffer RAM and SPI serial interface. Chip
supports programmable automatic retransmit
on collision and automatic rejection of
erroneous packets. Board contains standard
RJ-45 connector, transmit, receive and power
LEDs. On-board crystal oscillator ensures
stable operation. Board is designed to use
3.3V power supply only.
with an on-board MAC & PHY, 8K Bytes of
Buffer RAM and SPI serial interface. Chip
supports programmable automatic retransmit
on collision and automatic rejection of
erroneous packets. Board contains standard
RJ-45 connector, transmit, receive and power
LEDs. On-board crystal oscillator ensures
stable operation. Board is designed to use
3.3V power supply only.
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all the pins are aligned
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all the pins are aligned
correctly, push the board all the way
into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Board applications
Due to zero hardware configuration, this
board is the perfect solution for adding
Ethernet feature to your devices. ETH click
is driven using SPI communication lines.
Target applications include VoIP, Industrial
Automation, Building Automation, Home
Control, Security and Instrumentation, etc.
board is the perfect solution for adding
Ethernet feature to your devices. ETH click
is driven using SPI communication lines.
Target applications include VoIP, Industrial
Automation, Building Automation, Home
Control, Security and Instrumentation, etc.
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down, so that
bottom side is facing you upwards. Place
shorter parts of the header pins in the
both soldering pad locations.
bottom side is facing you upwards. Place
shorter parts of the header pins in the
both soldering pad locations.
ETH
click
Before using your click board, make sure
to solder the provided 1x8 male headers
to both sides of the board. Two 1x8 male
headers are included with the board in
the package.
to solder the provided 1x8 male headers
to both sides of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
ETH click Manual
ver. 1.00
0 100000 018897