Atmel Xplained Evaluation Board AT32UC3A3-XPLD AT32UC3A3-XPLD 数据表
产品代码
AT32UC3A3-XPLD
757
32072H–AVR32–10/2012
AT32UC3A3
28.6.3
Waveform Operating Mode
Waveform operating mode is entered by writing a one to the CMRn.WAVE bit.
In Waveform operating mode the TC channel generates one or two PWM signals with the same
frequency and independently programmable duty cycles, or generates different types of one-
shot or repetitive pulses.
frequency and independently programmable duty cycles, or generates different types of one-
shot or repetitive pulses.
In this mode, TIOA is configured as an output and TIOB is defined as an output if it is not used
as an external event.
as an external event.
shows the configuration of the TC channel when programmed in
Waveform operating mode.
28.6.3.1
Waveform selection
Depending on the Waveform Selection field in CMRn (CMRn.WAVSEL), the behavior of CVn
varies.
varies.
With any selection, RA, RB and RC can all be used as compare registers.
RA Compare is used to control the TIOA output, RB Compare is used to control the TIOB output
(if correctly configured) and RC Compare is used to control TIOA and/or TIOB outputs.
(if correctly configured) and RC Compare is used to control TIOA and/or TIOB outputs.