Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-MICRO IMX233-OLINUXINO-MICRO 用户手册
产品代码
IMX233-OLINUXINO-MICRO
OLIMEX© 2012
OLinuXino-MICRO user's manual
CHAPTER 2: SETTING UP THE OLINUXINO BOARD
2. Introduction to the chapter
This section helps you set up the OLinuXino development board for the first time. Please consider
first the electrostatic warning to avoid damaging the board, then discover the hardware and software
required to operate the board.
first the electrostatic warning to avoid damaging the board, then discover the hardware and software
required to operate the board.
The procedure to power up the board is given, and a description of the default board behavior is
detailed.
detailed.
2.1 Electrostatic warning
OLinuXino is shipped in a protective anti-static package. The board must not be exposed to high
electrostatic potentials. A grounding strap or similar protective device should be worn when
handling the board. Avoid touching the component pins or any other metallic element.
electrostatic potentials. A grounding strap or similar protective device should be worn when
handling the board. Avoid touching the component pins or any other metallic element.
2.3 Requirements
In order to set up the OLinuXino-MICRO optimally, the following items are required:
- 5V source of power with 1A maximum amperage.
- SJTAG interface programmer
- USB hub (USB splitter)
- USB keyboard
- Monitor with composite interface or Personal Computer + USB-SERIAL-CABLE
- SD card with Linux image
- SJTAG interface programmer
- USB hub (USB splitter)
- USB keyboard
- Monitor with composite interface or Personal Computer + USB-SERIAL-CABLE
- SD card with Linux image
Note that the board arrives without SD card or Linux image. You can purchase a card with Linux
separately. It is recommended that the user has basic Linux experience.
separately. It is recommended that the user has basic Linux experience.
Some of the suggested items can be purchased by Olimex, for instance:
iMX233-OLinuXino-SD - SD card with the Linux image
USB-SERIAL-CABLE-F - USB serial console cable female (check “6.1.1 UART Debug” for info
how to connect it to the board)
SY0605E - power supply adapter 5V/1A for iMX233-OLinuXino-MICRO
iMX233-OLinuXino-SD - SD card with the Linux image
USB-SERIAL-CABLE-F - USB serial console cable female (check “6.1.1 UART Debug” for info
how to connect it to the board)
SY0605E - power supply adapter 5V/1A for iMX233-OLinuXino-MICRO
Page 8 of 47