Olimex USB AVR ISP MKII compatible AVR programmer with ICSP PDI TPI support AVR-ISP-MK2 AVR-ISP-MK2 数据表
产品代码
AVR-ISP-MK2
OLIMEX© 2013
AVR-ISP-MK2 user's manual
4.2.3 Using Arduino IDE with AVR-ISP-MK2
1. Download latest Arduino IDE and run it
2. Plug the AVR-ISP-MK2 to the computer and follow chapter 4.2.1 for firmware and driver install
3. Power your target Arduino-compatible board via the AVR-ISP-MK2 (setting the jumpers
properly) or externally (make sure AVR-ISP-MK2 doesn't provide additional voltage – TERGET
jumper is set to OFF)
4. Make sure you use the correct interface. If you need adapter cable (10-pin ICSP to 6-pin ICSP) –
please check the schematic at the next chapter – 4.2.4
5. Set the correct values for board and programmer in the Arduino IDE – Tools->Board and Tools-
>Programmer.
2. Plug the AVR-ISP-MK2 to the computer and follow chapter 4.2.1 for firmware and driver install
3. Power your target Arduino-compatible board via the AVR-ISP-MK2 (setting the jumpers
properly) or externally (make sure AVR-ISP-MK2 doesn't provide additional voltage – TERGET
jumper is set to OFF)
4. Make sure you use the correct interface. If you need adapter cable (10-pin ICSP to 6-pin ICSP) –
please check the schematic at the next chapter – 4.2.4
5. Set the correct values for board and programmer in the Arduino IDE – Tools->Board and Tools-
>Programmer.
6. Open a simple blinking LED example and adjust the pin values according to the schematic of
your device (some boards doesn't require a pin number change).
7. Remember to click “Upload Using Programmer”! By default the right arrow in the interface
would attempt to upload via the bootloader!
your device (some boards doesn't require a pin number change).
7. Remember to click “Upload Using Programmer”! By default the right arrow in the interface
would attempt to upload via the bootloader!
Special mention for Olimex boards – sometimes the board refuses to reset before programming
when using Arduino. Try holding the reset button and release it simultaneously while clicking
“Upload Using Programmer”.
when using Arduino. Try holding the reset button and release it simultaneously while clicking
“Upload Using Programmer”.
Page 14 of 22