Olimex Open Source Hardware Embedded ARM Linux Single board computer with i.MX233 ARM926J @454Mhz IMX233-OLINUXINO-MAXI IMX233-OLINUXINO-MAXI 数据表
产品代码
IMX233-OLINUXINO-MAXI
OLIMEX© 2012
OLinuXino-MAXI user's manual
6.13 Additional hardware components
The components below are mounted on OLinuXino but are not discussed above. They are listed
here for completeness:
here for completeness:
Reset button - used to reset the board
Power button – when Linux is running pressing PWR_BUT will put the board in low power mode;
when powered by battery PWR_BUT is used to initially power up the board – and pressing the
board again after it is powered will put it low power mode
when powered by battery PWR_BUT is used to initially power up the board – and pressing the
board again after it is powered will put it low power mode
Recovery pads (REC) - these can be used for attaching a recovery button; when powered by
battery the recovery button is used to bring the processor to normal power mode – you can short-
circuit the pads for this feature without having to mount a button
battery the recovery button is used to bring the processor to normal power mode – you can short-
circuit the pads for this feature without having to mount a button
512 (32M x 16) MBit DDR SDRAM - the exact memory used at the moment of writing is Xylinx
H5DU5xxxyyy
H5DU5xxxyyy
LED1 + Power LED
6.14 Accessories
Here you will find additional information for Olimex products you can use with OLinuXino-MAXI
purchase
purchase
6.14.1 USB-SERIAL-CABLE-F
The cable for the U_DEBUG interface that can be purchased for additional cost has three cables. It
is important to specify in your purchase order whether you want the USB-SERIAL-CABLE variant
with male a male or female connectors.
is important to specify in your purchase order whether you want the USB-SERIAL-CABLE variant
with male a male or female connectors.
You will need a drivers that can be downloaded from the page of USB-SERIAL-CABLE:
Page 48 of 60