Olimex Open Source Hardware Embedded ARM Linux single board computer with Allwinner A10 Cortex-A8 A10-OLINUXINO-LIME A10-OLinuXino-LIME 用户手册

OLIMEX© 2014

A10-OLinuXino-LIME user's manual

refer to chapter 2.5 “Changing the default image resolution” for more information.

Please note that most the jumpers on the board are SMT type. If you feel insecure of your 
soldering/cutting technique it is better not to try to adjust the jumpers since it is possible to damage 
the board.

SMT

Either CLOSED or 
OPEN, depending 
whether the board 
has 4GB NAND 
MEMORY MODULE

Controls whether the NAND memory 
module is enabled or disabled.

If the jumper is closed than the 
NAND memory is operational.

SMT

PC3

Controls which processor pin should
be used for SATA power enabling 
signal. By default the SATA 
powering control uses processor pin
L22 which is port PC3.

Changing this jumper also changes 
the availability of PC3 and PB8 at 
GPIO-1 pin 29 and GPIO-3 pin 16.

Please note that if you change the 
position of the jumper from PC3 to 
PB8 then you might block one of the
processor pins responsible for I2S 
and AC97 audio output.

SMT

PB9

Controls which processor pin should
be used for the USB_OTG. By default
the USB_OTG uses processor pin C12 
which is port PB9. The same 
pin/port is used for I2S audio. In 
case you want to access the I2S 
capabilities of the board you would
need to change the default 
position. 

SMT

PH7_GPIO

PB9/PH7_GPIO jumper controls which 
of the two ports (PB9 or PH7) 
should be lead out to pin 9 of 
GPIO3 connector for easier access.

Changing this jumper also changes 
the signal available at GPIO-3 
connector's pin 9.

By default this jumper is in 
PH7_GPIO position and PH7 is lead 
to pin 9 of GPIO3. 

Page 34 of 42