Olimex Open Source Hardware ARDUINO-like development board OLIMEXINO-5510 OLIMEXINO-5510 用户手册

OLIMEX© 2012

OLIMEXINO-5510 User's Manual

In this chapter is located the information about the heart of OLIMEXINO-5510 – its microcontroller 
MSP430F5510. The information is a modified version of the datasheet provided by its 
manufacturers. 

w Supply-Voltage Range, 1.8 V to 3.6 V



 Ultra-Low Power Consumption

- Active Mode (AM)
- All System Clocks Active

- 195 µA/MHz at 8 MHz, 3 V, Flash Program Execution (Typical)
- 115 µA/MHz at 8 MHz, 3 V, RAM Program Execution (Typical)

- Standby Mode (LPM3)

- Real Time Clock With Crystal, Watchdog, and Supply Supervisor Operational, Full RAM 
Retention, Fast Wake-Up: 1.9 µA at 2.2 V, 2.1 µA at 3 V (Typical)
-Low-Power Oscillator (VLO), General-Purpose Counter, Watchdog, and Supply Supervisor 
Operational, Full RAM Retention, Fast Wake-Up: 1.4 µA at 3 V (Typical)

- Off Mode (LPM4)

- Full RAM Retention, Supply Supervisor Operational, Fast Wake-Up: 1.1 µA at 3 V 
(Typical)
- Shutdown Mode (LPM4.5) 0.18 µA at 3 V (Typical)



 Wake-Up From Standby in Less Than 5 µs



 16-Bit RISC Architecture, Extended Memory, Up to 25-MHz System Clock



 Flexible Power Management System

- Fully Integrated LDO With Programmable Regulated Core Supply Voltage
- Supply Voltage Supervision, Monitoring, and Brownout


 Unified Clock System

- FLL Control Loop for Frequency Stabilization
- Low-Power Low-Frequency Internal Clock Source (VLO)
- Low-Frequency Trimmed Internal Reference Source (REFO)
- 32-kHz Watch Crystals (XT1)
- High-Frequency Crystals up to 32 MHz (XT2)


 16-Bit Timer TA0, Timer_A With Five Capture/Compare Registers

Page 13 of 29