Olimex The smallest Arduino-inspired board Olimex OLIMEXINO-85-ASM OLIMEXINO-85-ASM 用户手册
产品代码
OLIMEXINO-85-ASM
OLIMEX© 2013
OLIMEXINO-85 user's manual
8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)
Operating Voltage
1.8 - 5.5V for ATtiny25V/45V/85V
2.7 - 5.5V for ATtiny25/45/85
Speed Grade
ATtiny25V/45V/85V: 0 – 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 – 5.5V
ATtiny25/45/85: 0 – 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 – 5.5V
Industrial Temperature Range
Low Power Consumption
Active Mode:
1 MHz, 1.8V: 300 µA
Power-down Mode:
0.1 µA at 1.8V
More information can be found at Atmel's web site at the following web-address:
4.2 Serial programming of the microcontroller
The table below details the proper connections needed to establish between ICSP programmer and
the board's microcontroller (ATtiny85) or to the GPIO connector (e.g. you don't need to remove the
microcontroller from its plastic socket, you can lead the proper signals to the GPIO connector of
ATtiny85).
the board's microcontroller (ATtiny85) or to the GPIO connector (e.g. you don't need to remove the
microcontroller from its plastic socket, you can lead the proper signals to the GPIO connector of
ATtiny85).
To establish the connection below you would need at least 6 jumper wires (male-female). If you
connect the ICSP programmer tool to the GPIOs ignore the “TINY85” column in the table. If you
connect the ICSP programmer tool to the TINY85 directly (or via a socket) ignore the “GPIO
connector name” column.
connect the ICSP programmer tool to the GPIOs ignore the “TINY85” column in the table. If you
connect the ICSP programmer tool to the TINY85 directly (or via a socket) ignore the “GPIO
connector name” column.
Cable connection
6-pin ICSP
TINY85
GPIO connector name
1
6
1
2
8
VCC
3
7
2
4
5
0
5
1
RST
6
4
GND
How to determine first pin of the above connectors and interfaces – the ICSP programmer should
have a mark on the connector for its first pin (or the cable leading to the connector would have a
different color on the side of first pin); the TINY85 has a dot that shows which pin is the first one;
the GPIO connector has the names of the pins printed on the top of the board.
have a mark on the connector for its first pin (or the cable leading to the connector would have a
different color on the side of first pin); the TINY85 has a dot that shows which pin is the first one;
the GPIO connector has the names of the pins printed on the top of the board.
Page 13 of 22