Olimex Development board for 18 pin PIC microcontrollers PIC-IO PIC-IO 用户手册
产品代码
PIC-IO
OLIMEX© 2012
PIC-IO User's Manual
have real RS232 driver (like PC) if you try to connect two PIC-IO boards by RS232 the
connection will fail as no one of the boards will generate the negative levels.
connection will fail as no one of the boards will generate the negative levels.
The on-board ICSP connector allow you to program the PIC on the board without pulling it of
the socket, by ICSP programmer like PIC-MCP, PIC-MCP-USB, PIC-PG1, PIC-PG2, PIC-
PG3, PIC-PG4 or to program and debug it with PIC-ICD2, PIC-ICD2-POCKET or PIC-
ICD2-TINY. IMPORTANT: all programmers provide power supply through ICSP connector
during the programming PIC-IO should not be powered via the external power jack!
the socket, by ICSP programmer like PIC-MCP, PIC-MCP-USB, PIC-PG1, PIC-PG2, PIC-
PG3, PIC-PG4 or to program and debug it with PIC-ICD2, PIC-ICD2-POCKET or PIC-
ICD2-TINY. IMPORTANT: all programmers provide power supply through ICSP connector
during the programming PIC-IO should not be powered via the external power jack!
The power supply circuit have protection diode for reverse connection. The positive point is
the internal pin of the power jack. The input voltage could be in range 12–14V DC.
the internal pin of the power jack. The input voltage could be in range 12–14V DC.
The oscillator circuit is made with 20 Mhz crystal oscillator, so you can run your PIC at
maximum performance.
maximum performance.
The RESET is connected with 10K to +5V and allow safe use of PIC-ICD2 or PIC-MCP
programming.
programming.