Olimex Prototype board for STM32F107 CORTEX-M3 microcontroller STM32-P107 STM32-P107 用户手册
产品代码
STM32-P107
REVISION AND ORDERING INFORMATION
STM32-P107 – fully assembled and tested
You can purchase directly from our online shop or from any of our distributors. Note that usually it is
faster and cheaper to purchase Olimex products from our distributors. List of confirmed Olimex LTD
distributors and resellers:
faster and cheaper to purchase Olimex products from our distributors. List of confirmed Olimex LTD
distributors and resellers:
for more info.
Manual revision history:
REV. I
- created December 2009
REV. A
- edited by TU December 2010
REV. B
- demo software added and mechanical dimensions detaile
REV. C
- rev. A schematic and added more programmers in BOARD USE
REQUIREMENTS.
REQUIREMENTS.
REV. D
- edited June 2011 – changed schematic
REV. E
- changed schematics to rev. B, added board revision history
REV. F
- added BOOT0_E, RST_E description, changed dimensions, updated
revision B pictures, updated disclaimer
revision B pictures, updated disclaimer
REV.G
- updated the information to fit board revision C, updated schematics,
improved document layout, added product support information, updated
links
improved document layout, added product support information, updated
links
Board revision history:
rev. A
========
1. ST2052BD is exchanged with LM3526-L.
2. SD/MMC signals are changed as follows:
========
1. ST2052BD is exchanged with LM3526-L.
2. SD/MMC signals are changed as follows:
SPI1_MOSI ->
SPI3_MOSI
SPI1_SCK
->
SPI3_SCK
SPI1_MISO ->
SPI3_MISO
and SPI1_NSS renamed to CS_MMC
3. Changed the polarity to + of C36
3. Changed the polarity to + of C36
rev. B
========
1. All element libraries are now updated
2. Ethernet PHY is changed from STE101P to MICREL's one - KS8721BLMM
3. All 10uF/6.3V/TANT are changed to 0805 and a lot of element names are changed.
4. PWR_SEL jumpers are replaced by diodes.
5. USART3 is connected to UEXT while USART2 is connected to RS232 and bootloader functionality is
enabled! Two additional jumpers are added!!!
6. Added UEXT_PWR_E jumper!
7. A lot jumpers are added into jumpers description table
========
1. All element libraries are now updated
2. Ethernet PHY is changed from STE101P to MICREL's one - KS8721BLMM
3. All 10uF/6.3V/TANT are changed to 0805 and a lot of element names are changed.
4. PWR_SEL jumpers are replaced by diodes.
5. USART3 is connected to UEXT while USART2 is connected to RS232 and bootloader functionality is
enabled! Two additional jumpers are added!!!
6. Added UEXT_PWR_E jumper!
7. A lot jumpers are added into jumpers description table