Losi Brushless 1:8 RC model car Electric Buggy LOS04003 用户手册

1.  Steering Wheel Controls direction (left/right) of the model
2.  Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3.  Antenna Transmits the signal to the model
4.  ON/OFF Switch Turns the power ON/OFF for the transmitter
5.  Indicator lights 

 - Solid green light—indicates adequate battery power
 - Flashing green light—indicates the battery voltage is critically low. Replace batteries

6.  ST Trim Adjusts the total steering travel
7.  TH Trim Adjusts the total throttle travel
8.  ST Rate Adjusts the AVC sensitivity
9.  BIND Button Puts the transmitter into Bind Mode
10. ST. REV Reverses the function of the steering when the wheel is turned left or right
11. TH. REV Reverses the function of the speed control when pulled back or pushed forward

1.  Push in the battery cover a small amount to release the retaining tab, then remove the cover.
2.  Install 4 AA batteries, taking care to align the battery polarity to the diagram in the transmitter’s 

battery case.

3.  Carefully reinstall the battery cover by aligning the tabs with the slots on the transmitter. 

 CAUTION: Do not remove the transmitter batteries while the model is powered  

on or while operating, as a loss of model control, damage or injury can result.

For more information on the transmitter, go to www.horizonhobby.com and click  
on the support tab for the Spektrum DX2E to download the instruction manual.

5

1

2

3

4

8

6

7

9

10

11

13

14

15

16

17

12