Carson BRUSHLESS-SET DRAGSTER PRIME 14T 500906164 用户手册

Before using your new DRAGSTER Brushless Controller for the first time please 
note the following:

• 

Please read this manual carefully before using your new CARSON DRAGSTER 
PRIME Brushless Controller!

• 

Always make sure that you have the right gear ratio. The vehicle must not be 
geared low over a long period. 

• 

Only use original and suitable CARSON SHOOTER BL motors. 

• 

Stop driving immediately if the cooling fan fails.

• 

Do not connect the battery cable (plus and minus) with reversed polarity. 
The guarantee is not valid if a short circuit occurs.

• 

Select the correct battery type/under-voltage protection (Cut-Off).

To ensure that best operation of the electronic speed controller is not compromised 
by default settings on the transmitter, certain settings on the remote transmitter 
should be reset before programming the speed controller.

• 

Set the upper end stop for the throttle/brake servo to maximum by selecting 
the highest level for the upper EPA/ATV setting.

• 

Set the lower end stop for the throttle/brake servo to maximum as well by 
selecting the highest level for the lower EPA/ATV setting. 

• 

Set the trim of the throttle/brake lever to the middle position. 

• 

Select the neutral position for the throttle/brake lever: 

 

For training journey at e.g. 50/50 full throttle/braking 
(with reverse travel)  

 

For racing mode at e.g. 70/30 full throttle/braking 
(without reverse travel)