Carson BRUSHLESS-SET DRAGSTER PRIME 6T 500906160 用户手册
产品代码
500906160
36
CARSON DRAGSTER Brushless-Regler
GB
6. Setting the electronic speed controller by
means of the setup card
means of the setup card
1. Connect the ESC to a suitable charged battery pack. Make sure the polarity is
correct.
2. Connect the receiver cable to the program card, making sure of the correct
polarity.
3. Select the desired function for your speed controller and insert the jumper
(connector) in the appropriate places.
4. Turn on the ESC and wait a few seconds. The red LED on the program card will
flash, then becomes solid to indicate settings are saved.
5. Turn off the ESC and unplug the program before use again.
Trouble-shooting
If the red LED on the program card does not light up, make sure the receiver cable
is connected with the correct polarity and make sure the battery pack is fully
charged.
is connected with the correct polarity and make sure the battery pack is fully
charged.
LED
RX (receiver)
connection
connection
Jumper
The following values
can be set using the card:
can be set using the card:
1
Motor Timing
2
Acceleration
3
Setting the braking power
4
Choice dragbrake
5
Choice of rotation
6
Choice of battery type