Carson Brushless 1:8 RC model car Electric Bugg 500409091 用户手册

In order to make the ESC fit the throttle range of your transmitter, you 
must calibrate it for the following cases; otherwise the ESC cannot work 
properly.

1)  Begin to use a new ESC

2)  Begin to use a new transmitter

3)  Change the settings of neutral position of the throttle lever, the ATV 

or EPA parameters, etc. 

There need to be set 3 points. They are the end point of “forward”, the 
end point of ”backward” and the neutral point.

The following pictures show how to set the throttle range with your 
transmitter.

A)  Switch off the ESC and turn on the transmitter. 

B)  Hold the “SETUP”-key of the ESC and then switch on the ESC. 

Release the “SETUP” key as soon as the red LED begins to 
flash.

OFF

ON

OFF

ON

The “SET” key of ESC is at the power switch (see picture).

If you don’t release the “SET” key as soon as the red LED begins to flash, 
the ESC will enter the program mode. In such case, please switch off 
the ESC and re-calibrate the throttle range again as described.

C)  Set the 3 points according to the steps.

Move the throttle lever at the neutral point, and then click the SET 
key. The green LED flashes 1 time. 

Move the throttle lever at the end point of forward direction, and 
then click the SET key, the green LED flashes 2 times. 

Move the throttle lever at the end point of backward direction, and 
then click the SET key, the green LED flashes 3 times. 

The throttle range is calibrated; the motor can be started after 
3 seconds.