Steinberg WAVELAB 8.5 RETAIL SOFTWARE 45370 数据表
产品代码
45370
Plug-in Reference
Steinberg VST 3 Plug-ins
746
Q-Factor (0.001 to 10000)
Sets the resonance or width of the filter.
Monitor (On/Off)
Allows you to monitor the filtered signal.
Attack (0.1 to 100 ms)
Sets the time after which the gate opens when it is triggered.
Hold (0 to 2000 ms)
Determines how long the gate stays open after the signal drops below the
threshold level.
threshold level.
Release (10 to 1000 ms or Auto mode)
Sets the time after which the gate closes (after the set Hold time). If the Auto
button is activated, Gate automatically finds the best release setting for the
audio material.
button is activated, Gate automatically finds the best release setting for the
audio material.
Range
Adjusts the attenuation of the Gate when it is shut. If Range is set to
, the
gate is completely shut. The higher the value, the higher the level of the signal
that passes through the shut gate.
that passes through the shut gate.
Input Gain Meter
Shows the input gain.
Compressor Section
The compressor reduces the dynamic range of the audio, making softer sounds
louder or louder sounds softer, or both. The compressor features a separate display
that graphically illustrates the compressor curve shaped according to your settings.
louder or louder sounds softer, or both. The compressor features a separate display
that graphically illustrates the compressor curve shaped according to your settings.
Threshold (-60 to 0 dB)
Determines the level where the compressor kicks in. Signal levels above the
set threshold are affected. Signal levels below are not processed.
set threshold are affected. Signal levels below are not processed.
Ratio (1:1 to 8:1)
Determines the amount of gain reduction applied to signals above the
threshold. A ratio of 3:1 means that for every 3 dB the input level increases,
the output level increases by only 1dB.
threshold. A ratio of 3:1 means that for every 3 dB the input level increases,
the output level increases by only 1dB.
Make-Up (0 to 24 dB)
Compensates for output gain loss, caused by compression. If the Auto button
is activated, gain loss is compensated automatically.
is activated, gain loss is compensated automatically.
Attack (0.1 to 100 ms)
Determines how fast the compressor responds to signals above the set
threshold. If the attack time is long, more of the early part of the signal (attack)
passes through unprocessed.
threshold. If the attack time is long, more of the early part of the signal (attack)
passes through unprocessed.